ExtremmeHU Question

[berner]

I was doing a card lastnight that glitched fairly quick but was extremely slow to clean and write to in ExtremeHU 3.5. It finally came back with an invalid ATR when I tried to patch the 3Mv3 hex to it. I unlooped it with Starglitch3.3 (works great!) and went back to ExtremeHU 3.5. It glitched and wrote normally. If it happens again where it writes slow, will I do any damage to the card if I shut down ExtremeHU while it's cleaning or writing? I'm still using my AIO with jumpers, BTW. Thanks.

[mili]

It is highly unlikely to do permanent damage.

mili

[mdeven]

It'll just loop it.... Been there...done that!
Mark

[berner]

Thanks guys!

[cookie2]

More ?'s. When a bin is written to card and cleaned, is the bin still in extreme or do you have to reopen the bin again before U write again? Is there a way to go back to main window after clean and write. ExtremeHU just says the process has been completed.

[midwest]

your bin will still be on the card after you clean it. just write whatever on it after you clean it. that bin will stay there untill you clone a new bin on top of it.