ul4s

[complies]

I friend just got a t911 but the atmel chip has not been flash yet. I was looking for the file in the download section but could not find it.

I'm looking for help to locate the file and also how to load the atmel chip as well.
Thx

[4x4]

It should already be flashed with UL4S ..

Check the card in Extreme and it will show the flash in the upper right corner ...

[complies]

That's what i thought myself but it doesn't recognize the loader. I get the no programmer found error. Unless my dip switch is not set properly?

[complies]

I found the xpflasher and i loaded the ul4s atmel of the t911 using dip switch 1 and 5. If i try to use extreme to read or write, i keep getting the same error:
ERROR: no programmer found on com1

Dipswitch was set at 2 and 5.

[4x4]

In the Extreme settings is it also set to com 1 ??

[complies]

The com setting in extreme is properly set.
Would anyone know what error you'd get if your atmel chip is empty?

[complies]

I unscrewed the t911 and remove the atmel chip and used it on another loader. Tried reading a card with extreme hu and it all work well. Extreme hu recognized that the atmel was programmed with ul4s. I re-inserted the atmel back in the t911 and tried reading a card with EHU and, again, i get the error. It seems to be a communication error between the com port and the loader.

When trying to read or load a card,m should the settings of the dip switch be 2 and 5?
and is the power supply 6v 500mA?

thx

[Chief]

2 and 5 should be correct...and use a 9V power supply. Can't speak for others...but personally, I've never had good luck with 6 or 7.5 volts, with ANY loader.

[fubr]

sounds like a bad cable or connecter in the loader.
it will unloop and load with 2 and 5 on and in some cases 2 and 4 on . 1 and 5 to flash. some times I had to power off loader and exit out of EHU and then restart , pwr up open EHU and there it would be when I was using ME.

[complies]

Thx guys,
Same thing with 9v power supply. It is not the cable as i use it with other loaders without any problems. Powering off,on, exit, enter, open, close, shut off, restart extreme hu, loader and laptop numerous times.
Is there a way i could check if the connector is faulty? The soldering seems to be fine but there is no way the see inside the connector itself.
Can i use a multymeter do verify the connector?

[Clutch]

i hated the t911... all it did was give me problem after problem... eventually i gave up and got a mik III and have loved it... good luck with the t911

[quazievil]

Forgive me but is the t911 plugged into com port 1?

[complies]

lol........yes it was.
Thx for all the replies but i gave up on that machine and returned it for a full refund. I guess the damn thing was just broke.

[dallg]

Hey Complies, Try switching to comm port 2, worked for me..