Dish 3700/2700's With 2800 TSOPs

[DTVismybitch]

I have 4 Dish receivers that are tagged by dishnet as being 3700/2700 models but J-Keys recognizes them as 2800's, the receiver ID on the receiver tag matches the receiver ID on J-keys. Can i just program a 2700/3700 TSOP to these things for BEV to get them to convert, or is there another way to go about this, seeing as BEV doe snot have a 2800 model and erasing SA5 will not do anything because the receiver will not accept the data stream update to cahnge teh receiver to a 2700c. Thanks.

[Dr.Doom]

There's a trick to make a 2800 convert to bell just run check switch , half way through it plug the sat feed and let it finish. Then plug it in and leave it on the Aquiring signal message with Bev plugged in . in 5 to 10 minutes u have bell. Or u could use a TSOP flash at virgin state so the guide will also download the logo.

[BirdieMod]

All the newer software versions on these are 2800 series. If you need x700, Just go back to a older revision reflash the tsop and eeprom and then stream update it to bell.

[DTVismybitch]

Sounds easy enough, I was thinking that myself last night, one more question though, won't I need to fix the X700 TSOP with specific Box Keys and IRD info via flashedit131? Thanks.