2700 lost signal after reflashing TSOP/EEPROM

[damirabal]

I have two identical 2700 with same build configs. One of them was ECM'd so I had to re-flash it. After I did, It lost satellite signal and I haven't been able to make it work.

Any ideas on what might have happened?

P.S.

I re-flashed it more than once to prevent that the TSOP/EEPROM was corrupt.

D.

[BirdieMod]

Two things can cause this, First, Rerun Check Switch and check transponder, You may need to set it to a dif number at first to see signal. 2nd after running check switch look at the instalation report it shows, See if the sats are listed as odd/even or all for the ones you are setup for, If not, The EEprom stores this info and is corrupt, Take the tsop image into the program flashedit2 and use that to create a virgin eeprom image, Flash that to the eeprom and rerun check switch again. Should fix it.

[damirabal]

Thanks.

I will try it and let you know.

D.

[damirabal]

It was a corrupt TSOP. Re-flased and works fine.