no power on 2800

[shadyman]

Okay this is my first crack at Charlie and this is what I did. Backed up tsop and eeprom. Left jtag connected to receiver cause it was soldered on.(was that a bad idea?) Disconnected jtag from computer. Programmed card with blocker. Hooked up receiver to dish and put card in. Went to signal strength screen so I could repoint dish. After about 30 seconds seconds the receiver turned off and would not power up. I tried restoring tsop and eeprom although I was not sure if that was the problem. The backups restored without any problems. The receiver still won't power up. The card still reads and writes fine. Any ideas on what happened and what I should try next?

[alwayswatching]

Okay this is my first crack at Charlie and this is what I did. Backed up tsop and eeprom. Left jtag connected to receiver cause it was soldered on.(was that a bad idea?) Disconnected jtag from computer. Programmed card with blocker. Hooked up receiver to dish and put card in. Went to signal strength screen so I could repoint dish. After about 30 seconds seconds the receiver turned off and would not power up. I tried restoring tsop and eeprom although I was not sure if that was the problem. The backups restored without any problems. The receiver still won't power up. The card still reads and writes fine. Any ideas on what happened and what I should try next?


i have the same problm almost i have a 2800 and my power light wont come back on at all may be some one can help us out please!!!!! i have a jtag on itand pin one is grounded put still when i go to program it it will only go to 99% then it comes up with a error i tryed every thibg alread can some one tell me another way that will get me green light on forsure or if some one is selling one let me know aslong as it works and it can be jtaged