Peak DCU error

[themorningshift]

Hi I am using Jkeys 2.9.9 and trying to read TSOP but after couple of try I get error saying Peak DCU error. Do you know what does that means? I don't get any BK # or IRD # . Anyone has any idea about this and also is it easy way to JTAG is soldering to the pad or not? Please let me know guys
I had the same problem you are having...All I had to do was change computers.
I first tried my laptop and didn't have any luck but as soon as I hooked everything up to my tower it read the ird and box keys right away.
To get the to the tsop there are a few more hoops you have to jump through...I think the procedure is different for different irds but for mine (2700), I have to jump pad one to ground before I can read the tsop, (I havent done it yet).
I used an older version of jkeys...Version 2.0.1.
Hope this helps.....I am still learning myself.

[TURBO12PSI]

Try Closing All Programs And Unpluging The Ird Than Plug It Back In End Open Jkeys It Should Fix The Problem It Happens A Lot On My 301.010 So I Unplug And Start Over And It Takes If It Happens When Programming The Flash And Gives A Big # Error Just Erase A Bunch Of Times And Unplug And Do It Again

Mike

[ki55tory]

Peak DCU error is a connections problem or a receiver that has had the TSOP completely erased. What model are you talking about. If it is a 301.013 then you are talking a whole different ballgame.

[ki55tory]

You need to JTAG it to get the boxkeys from jKEYS. Do some more reading around, the pieces will fall in place ....

[Fallon 2000]

Peak DCU error is a connections problem or a receiver that has had the TSOP completely erased. What model are you talking about. If it is a 301.013 then you are talking a whole different ballgame. i have a 301.013 doing this what is the fix? thanks

[Fallon 2000]

iwas kind of asking ki55toryn about this thanks anyway have a bad time with a 301.013

[ki55tory]

Fallon 2000: Try grounding R79 before you start jkeys with your jtag connected also. Make sure you have a current version of jkeys with the updated jkeys.def file in the same directory as this current version of jkeys.

[Fallon 2000]

got the pad #1 grounded to case. isn,t that the same as grounding r79 ? using jkeys 301.013

[ki55tory]

It is, but for some reason I find that grounding R79 is more reliable with 301.013's from my experience. I say this because I have been in the position where with PAD1 grounded I have been unable to do what I want with it correctly, but the moment I ground R79, that symptom goes away. Weird I know, but that is my experience.

[Fallon 2000]

ok thanks i'll give this a try.