Need Help with my 301.010

[anthony605]

Hi! I posted this in the magic card forum...im not sure if what forum is more proper. Here is my problem.....I have a 301.10 receiver that I frigged up!! My first problem was that I would get CARD NOT INSERTED CORRECTLY ERROR 019. I tried to re flash TSOP with a TSOP file from the download site. That didnt help. Now when I restored the original TSOP files, the reciever's power light wont go on. The TSOP still reads the receiver. I researched the forums and read that there is a 301-3100 resurrection file. I cant find this file in the downloads!! Anyone have this file or can help me out. I first want to get the receiver back to the power light going on and then ill work on the original problem... Thanks guys

[snakeeyes]

I just Down loaded this from the files this evening

Birdie" File is in DSSFTP.COM Echostar files section"
We try to keep the files there to keep this area running better, Files here slow down the site.
Thanks.

[anthony605]

THANK YOU!!! I will try it in the morning. Hopefully it will work. I wonder why i couldnt find it. thanks again

[anthony605]

Hi!! I still need help with my 301.010....I followed the resurrection instructions to the T and I still cant get the receiver to boot. I tried using Wall and still a no go! I get LSI error. Any other suggestions?? Thanks

[BirdieMod]

You unplugged the receiver after the flash was deleted and the bootstrap is not there to load and give the receiver LSI chip control over the TSOP now. Use Jkeys301c from dssftp.com files echostar files section. Ground pin 1 of the ird and reflash it now in jkeys, It will give you a error about lsi control unavailable, using slow mode. It will work, But may take up to 6 hours to reflash in slow mode, Let it finish and it should be good. Do flash 2 first, After that you can unplug it and plug it back in and regain lsi control and do flash one normal in a few minutes like normal then

[anthony605]

Birdie...Thanks for your help! I cant seem to find JKeys301c in the echostar section. I have JKEYS 2.9.11 installed. Can i use this version or do i need the 301c version. Also, i just want to check with you to be sure that i can ground pin 1 on my 301.010. I know you can ground pin 1 on a 301.013....just want to be sure its ok to do it to a 301.010. I would hate to screw this thing up worse than it already is... Thanks man!

[skinerd]

Card not inserted correctly with the magic card, can be due to a bad card password, if it has never worked, try a different password, someone posted one here and that worked for me.......