kelowna_pitboy
05-13-2004, 06:37 PM
1. With the odd circuits tsop lock version c, is the eprom lock also built in or do i have to do a different type of mod?
2. I backed up the two DT tsops and eprom. my file sizes for each tsop was 4096 and the eprom was 8k. did i get it all?
3. The receiver came with the yellow card (one of those refurbs). i check flash 2 address 7FFFFFAC and came back all 0000's. I have not put the new receiver in the stream yet. From what i have read, all 0's means it will accept any card. i am going to go camless mc. also my software is p069. should i still do the stream update or lock the tsops down now?
4. in camless mode mc, should i use rom 2, 3, or 10?
Things are going good to this point for me. jtag no problem. I just want to make sure i am on the right track and ensure i understand the odd circuits component as i am unclear, other than the tsop, what it is locking down.
kelowna pitboy
2. I backed up the two DT tsops and eprom. my file sizes for each tsop was 4096 and the eprom was 8k. did i get it all?
3. The receiver came with the yellow card (one of those refurbs). i check flash 2 address 7FFFFFAC and came back all 0000's. I have not put the new receiver in the stream yet. From what i have read, all 0's means it will accept any card. i am going to go camless mc. also my software is p069. should i still do the stream update or lock the tsops down now?
4. in camless mode mc, should i use rom 2, 3, or 10?
Things are going good to this point for me. jtag no problem. I just want to make sure i am on the right track and ensure i understand the odd circuits component as i am unclear, other than the tsop, what it is locking down.
kelowna pitboy