Kick Ass Clones "Wildthing" H unlooper need dip switch setting info

[packinDSS]

I have an old "Kick Ass Clones wildthing" H card unlooper, they were shut down along time ago, I think raided. It has 4 dip switches, an atmel chip, and 1 jumper on it. I remember that removing the jumper puts it in to pheonix mode( equivlant of puling pin 1 out of the socket on the atmel chip) for programming H cards, but I cannot remember what the dip switch settings were used for?

Anyone remember what the dip switch setting were used for?

Kick Ass Clones wildthing H card unlooper

[crash2881]

1,3,4 off and 2 on
Ensure that the atmel is flashed with su2bs01 for Black Sunday H card. Then place the H card in the the unlooper and power up. Start BasicH and do a read. It should be good to go.

Same switches and flash with UL4S. Change the flash cap, another cap and a resistor and clip atmel pins 13 & 14 and it's a bearly usable HU loader.

[packinDSS]

have you had any luck using it with Dish network cards?

[crash2881]

I hadn't even thought about using it with Charlie because the clock chip would probably have to be changed from 3.57Mhz to 3.68Mhz just to becgin. With Programmers so cheap or even building one from scratch, I wouldn'y think of modifying the KAC.