PDA

View Full Version : the Spot got damage

madea
06-04-2004, 04:23 PM
Hi I complete to reciever, but on the last reciever after I solder
a wire to the spot I damage it (i pull area up) .
It they a alternative area where i can solder wire to.
skinerd
06-04-2004, 04:30 PM
Yes, you can follow the trace below the board and it comes back to the top about 1/2 inch from there. Use 30 ga wire and if carefully heated you can slip it into the tiny hole for either spot, instead of trying to solder it to thay spot, which is easily pulled off.
The spot comes thru back to the top very near a circle with a spot in the middle, about 1/2 inch towards the back of the board right inline with the first spot, very easy to see.
madea
06-04-2004, 05:03 PM
Yes, you can follow the trace below the board and it comes back to the top about 1/2 inch from there. Use 30 ga wire and if carefully heated you can slip it into the tiny hole for either spot, instead of trying to solder it to thay spot, which is easily pulled off.
The spot comes thru back to the top very near a circle with a spot in the middle, about 1/2 inch towards the back of the board right inline with the first spot, very easy to see.


it it the circle left of U9 and above R100 , looking from back of rec. can I solder to this point.
skinerd
06-04-2004, 05:22 PM
it it the circle left of U9 and above R100 , looking from back of rec. can I solder to this point.

Not inside the circle, but the spot between the circle and the old spot. There are 2 spots side by side just like where the original one is, the one straight back from the original is the one.
madea
06-04-2004, 05:31 PM
Not inside the circle, but the spot between the circle and the old spot. There are 2 spots side by side just like where the original one is, the one straight back from the original is the one.


Thanks I think I got it now..
Qrash
06-04-2004, 07:38 PM
lexar guided me to the following:

"You can solder to R62 which is (looking from the front of the receiver) just to the left of the jtag. It is the same line... "

This is a very robust solder point ... the side toward the R62 stencil marking ... Qrash

**********************************************