Can someone please help?

[MR-MV]

I have a rom3 and a rom 10 card I pulled off some dead recievers I found at a swap meet. Is there any way to program theses without the reciever info. Or there a way I can pull the info off the card? Or maybe put a completlly different image off another card? Can someone please help?
Thanks

[terry96]

You could change the image if you'd like but all you have to do is change the info in data editor before you write to the card.(in nagra edit)

[skinerd]

Read the newbie guide MR MV.......it is obvious that you have not done so.......it is not that difficult, but you need to learn some of the ins and outs of how this stuff works together.

[MR-MV]

Read the newbie guide MR MV.......it is obvious that you have not done so.......it is not that difficult, but you need to learn some of the ins and outs of how this stuff works together.

I did some reading and from I understood I need the IRD# and boxkaeys from the reciever i'm going to use and not from the dead reciever it came from is that correct?

[terry96]

correct!