PDA

View Full Version : Blackout/Freezing at random times on different channels. Plz help !


inferno25k
06-22-2004, 06:40 PM
Hi,

I just got a new open rom10 card at revA16 and programmed it very carefully by following every step. At the beginning when i put my card in .. i just get a black screen with the channel header showing only. Once i start flipping channels they start showing up (video & audio) .. and then suddently they blackout again. Here is what i did ..

. Entered correct boxkeys, ird#, publickeys. (triple checked all of them)
. Created tier patch using minirtm2.5 ( tried with only 1 package too .. )
. Tested rom10nomore64-7 & checksum2.4 blockers ( both gave me same result)
. Tried 3 different rom10 camid's (2 of them were generated using scammerv2)
. Tried 2 different Zipcodes & timezone.

I tried this card on another receiver but this time it was freezing instead of blacking out. I presume it's the same thing .. just different ird's doing different things. Both receivers have the latest firmware installed.

I am running out of ideas since I have tried almost everything.
Any help would be greatly appreciated.

Thank You !!!

2getwired
06-23-2004, 03:23 AM
check ur cam and boxkey numbers again. 0 for o and 8 for B's etc. try yatm09 for "latest" tier maker[ez'r and better luck] when u made ur tier, did u choose the right rom#? do u have a location id of better than 000000001 in ur ird sys info? HTH

inferno25k
06-23-2004, 06:31 PM
Yes, boxkeys & cam have been checked many times .. my ird's are fine, location id is other than 00000001 .

Channels are showing but they are blacking out at random times ... some channels are faster than others. I also tried rtm119, no help :(
I will try YATM but i doubt it will do any good ...

Any help is appreciated ..
ty

2getwired
06-23-2004, 08:05 PM
try this... using yatm09 create new tiers. do not include sytem info, ie. cam, keys etc. only enter that info in nagra. apply this and ur blocker in that order.
make sure the cam # you convert to hex and use in nagra does not include the first 0's or the numbers after the dash.
if all else fails find a cam from another card that you have not yet tried. good luck!