programming atmega

[inkredable1]

can anyone tell me if you can program an atmega to run on two recievers...i know you'd have to go into jeepers and change the boxkeys and ird number, but can the atmega go from a 3100 to a 2700 reciever by just being reporgrammed in jeepers or is it something more that has to be done...

[nova]

Just change boxkeys and ird # and it should work fine

[inkredable1]

yeah i tried that, i used the same pfg that works for my 3100 and still no result....i get the card not inserted correctly, or the searching for satellite...

thanks for your help

[nova]

I am using angelvision from the downloads area and it is working fine on both my 3100 and 2700......Give it a try if your not using it already......Sorry I couldn't be more helpful maybe someone else will be able to help....Good Luck

[inkredable1]

thanks for your help...a new suggestion is always some ray of hope...

i'll keep you all posted on my success'

[turnip bandit]

angelvision is for dish not bev for bev use sexy 383

[nova]

Check again turnip angel vision v1.0 is bev and angel vision v3.0 is dish.....I,m running v1.0 right now and it works well....but it never hurts to have a backup i'm gonna check out sexy 383.......I don't see sexy 383 in the files area....

[turnip bandit]

im sorry i have been away for awhile and done some homework and found angelvision is for bell sorry for misinformation and i posted 383 in another post
__________________