Very useful help doc gone...

[m5runner]

Hi Mili, earlier there was a step by step guide link on the main page. I used it to modify my Rca 420 with the nozkt file. The guide had all the instructions including pictures of how to solder on the jtag and it had instruction for setting up the jtag software to up/down load the bins's. I found it very easy to follow.


Now the link is gone but I don't think you have delete it. Any chance you could post it or pm my a copy? My memory is a little foggy in recalling the correct command order to reload my original bin back into the flash.

Thanks

Uhh.




just curious why you would want to change it back to the original flash. your IRD should still work with the no zkt flash on it. if you want to switch back for some ungodly reason, take the ground that is connected to FP and put it on the 5 volt side and let dave update the firmware.