Atmega Black Screen and Banners

[junglee]

Hi,
I have tried using multiple files program my 10-pin jumperless atmega128 card. The programming completes successfully. When I put the card in the receiver, I am able to get the promo channel and guide. However for the rest of the channels, I get a black screen and a banner on top.
I can't figure out what is wrong. I've double checked the keys and they are correct
Any ideas?

[tester293]

1. Double check box keys
2. Use a valid rom3 cam id
3. put card in ird, tune to ch 101, wait 15 min b4 u try anything.............

[junglee]

1. Double check box keys
2. Use a valid rom3 cam id
3. put card in ird, tune to ch 101, wait 15 min b4 u try anything.............

Thanks for the response..
I tried your suggestions with no luck..still getting the blank screen...
So close...yet no picture...

[tester293]

Let you ird do a update.........

[ecm_this]

Ya know that in hex there are NO letter Os.If you have 'em in the BKs change 'em to number 0.

[CYCO]

Thanks for the response..
I tried your suggestions with no luck..still getting the blank screen...
So close...yet no picture...
Junglee I am having same proplem> Have you found the answer to this yet? It has got me! I can't figure out what is missing here :eek13:

[mudbug_kid]

cyco,,got to menu,6,1,3 and check your ird software version,ps wot ird do you have

[CYCO]

cyco,,got to menu,6,1,3 and check your ird software version,ps wot ird do you have
It is my subbed 301.010 and is up to date on s/w revision. Thanks

[Masta_Mind1]

well just pull out your jtag again and make sure you are using the right boxkeys
because if you have wrong boxkeys then you get blank screen... doesnt hurt to check

[CYCO]

well just pull out your jtag again and make sure you are using the right boxkeys
because if you have wrong boxkeys then you get blank screen... doesnt hurt to check
I have checked them and they are correct.Thanks but it has to be something else :cry:

[CYCO]

well just pull out your jtag again and make sure you are using the right boxkeys
because if you have wrong boxkeys then you get blank screen... doesnt hurt to check
Masta_Mind1 Thanks thats what i needed I had 1 of the box keys copied wrong :rolleyes: Must be getting OLD TIMERS disese :eek13:

[bubz24]

I have had success with this problem by replacing the crystal on my 18.0 MHz Atmega to a 16.0 MHz. This seems to work with those buggy Atmega chips that don't seem to work with the NNW21 code.

I found that the Atmega will work with the older .pfg files such as nawapo 18 but once the newer nnw21 came out it would not take. The changing of the crystal speed seemed to do the trick.

Regards,

Bubz

[moonlighting]

If all the above suggestions is a no go then put a jumper on pins 2 and 9, program external they insert in the ird (leave jumpers on)....if no go after that try a different pfg. If no go after that then I'm outta suggestions....lol.