Blue Button Remote codes.

[kissmydish]

:Blasting_ Say does anyone have all the TV and VCR codes for all the makes and models for the Blue Button remotes?I would like to get my Sony Wega tv on the same remote as the Sattilite remote.

Any help with this would be greatly Thankful.

[indal_98]

:Blasting_ Say does anyone have all the TV and VCR codes for all the makes and models for the Blue Button remotes?I would like to get my Sony Wega tv on the same remote as the Sattilite remote.

Any help with this would be greatly Thankful.

dishnetwork.com/content/customerCare/technical/index.shtml

[4x4]

Good info indal ,

I took out the " www. " as it could be traced back to this site when clicked on ...

[r58pan]

Did not no this 4X4 thinks for posting this info will rember

[kissmydish]

I would like to know that as well

[reb43]

I would like to know that as well

If I remember, which I doubt, just hlod down whatever button you are programming until it blinks, then put the numbers in and hit power.. If it goes off it works, make sure the unit (TV, VCR) is on when putting the numbers in. I hope my memory is better than I think it is.

[kissmydish]

I don't think that works.The reason why i say that is because when i did that it turned off the recevier not the TV

[indal_98]

I don't think that works.The reason why i say that is because when i did that it turned off the recevier not the TV

Doesn't anyone search for info anymore ?

The link I gave has all that info ....

C/P from dishnetwork.com

1) If your remote has blue buttons and 4 separate mode buttons (SAT TV VCR AUX)

If you start this procedure and at any time do not press a button within 20 seconds, the remote will end the procedure automatically. Simply start over again.

Press and hold the correct Mode button (about three seconds) until all mode keys light up, then release.

Use the number pad buttons to enter the three digit number corresponding to the equipment. The light will blink off after each digit is entered and then return to a steady light.

Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.

To verify the code works, press the mode button and then try several functions for that equipment.



2) If your remote has 1 mode button at the top

If you start this procedure and at any time do not press a button within 20 seconds, the remote will end the procedure automatically. Simply start over.

With the desired equipment on, press and release the Mode button until the light flashes behind the correct mode.

Using the tip of a pen or the eraser on a pencil, press the address button.

Enter the code on the remote's numbered keypad for the equipment.

Press the Address button. If the code entered is valid for the remote, the mode light flashes three times.

To verify the code works, try several functions for that equipment. Some codes may provide partial functions or respond differently than the button's titled function. Try the other codes listed for that device until you find one that offers more complete functionality.

[JCK7]

indal_98 How do set remote 2 have 2 rec in same room 301 and 721 turn 1 on both come on. don't see in guide how set to remote 2/ JCK7

[4x4]

This is right out of the manual ..