ziac
07-21-2004, 06:17 PM
ok here is my problem i am kind of a noob to charlie i have a 310-13 single tsop it came with a rom 10 card so i have not doen a vid mod but jtaged with the sticky here on jtagging and it semed to work just fine i got ecmed and i had not let my reciver update so i erased sector sa50 and reprogramed the eprom to 201 and restreamed and it came back and updated to 203 i did not remove my ppv so i got ecm agin so reprogramed eprom agin and removed ppv from card and restreamed ( mistake i think ) it came back but the only channels i got was 101 and a 9000 one said i had dish 500 system i think i should have just went into reciver at that point and erased sa50 agin but insted i decided reflash my tsop and eprom back to 201 and let it update when i reflashed my tsop it seemed to work fine i used the one i saved like it siad to do in sticky but now my ird is dead it does not show build config in jkeys so i went back to the new sticky down loaded it and tryed to do the tsop redo as it sayes there but with no luck same results so then i went to downloads and got public dump of my eprom daha and used flash edit to add ird box keys and tryed agin same results do i need to do a vid mod on my ird to fix this problem even tho it came with rom 10 card ?? i know i messed up here and i think i should have just erased sa 50 restremed and not messed with tsop any further but i need so help now to get this back working agin thanks in advance for any help i can get