3900 flashing error reading from IRD DCU Peak

[rogerlongview]

Trying to reflash my 3900 for the first time. I keep getting an error " error reading from IRD (DCU Peak)

Any ideas at all?

[JShin]

Check your Jtag connections and try resetting the IRD by unplugging it and replugging it.

[rogerlongview]

I left it alone for about 20 minutes and started over. Everyhting is working now. Sorry for the post, it just didn't make any sense and I have not seen anyone wiht that error before. I thought that I might have fried the reciever. But all ended well

Thanks for the help

[ninerblood]

Am getting that error on my 2800, verified all connection. Ive tried fixing this receiver for 10 hours now after the ecm and it keeps getting worse. First I tried erasing the proper sectors but it wouldn't reset (tried several times). Then tried doing a fully restore TSOP and it wouldnt let me program my original backup TSOP. And now i get that message when trying to read the receiver.

[Cid6.7]

Am getting that error on my 2800, verified all connection. Ive tried fixing this receiver for 10 hours now after the ecm and it keeps getting worse. First I tried erasing the proper sectors but it wouldn't reset (tried several times). Then tried doing a fully restore TSOP and it wouldnt let me program my original backup TSOP. And now i get that message when trying to read the receiver.


Try a different printer cable...Worked like a charm for me

[loserbaby]

that is strictly a connection error, something is wrong with your solder conns, wires too long, or if your using pogo pins...bad connection.