2800 with Dig Lock

[bloodhound]

2800 with Dig Lock

--------------------------------------------------------------------------------

I have a 2800 with a dig lock on it and after the ecm on the 20th all I get is 2 info channels. My location # is 01, my ? is how to go about fixing this problem. Thanks in advance.

[srad750]

erase sectors SA5 three to five times using jkeys. then connect receiver to sat input first, then plug in power. do not turn power on, receiver should start blinkung buy it self. that means it is updating. when it is finished "insert card " will pop up, do a sytem info and make sure that your location is anything other than 0000001. and thats it. if that does not work try again. oh by the way when you use jkeys follow these steps

1) hook up jtag and ground wire to receiver
2) plug in power
3) start jkeys

[jscotton77]

If You Dont Have A Jtag You Can Get A Jumper Wire And Short Pins Sb39 And Sb40 Count To 20 And Then Release Works Everytine

[bloodhound]

erase sectors SA5 three to five times using jkeys. then connect receiver to sat input first, then plug in power. do not turn power on, receiver should start blinkung buy it self. that means it is updating. when it is finished "insert card " will pop up, do a sytem info and make sure that your location is anything other than 0000001. and thats it. if that does not work try again. oh by the way when you use jkeys follow these steps

1) hook up jtag and ground wire to receiver
2) plug in power
3) start jkeys

Thanks it took several times but this worked. Now if Charlie would just go back to sleep. LOL

[bloodhound]

If You Dont Have A Jtag You Can Get A Jumper Wire And Short Pins Sb39 And Sb40 Count To 20 And Then Release Works Everytine


I am going to install a push button to do this in the future. I have 2 fixed that way already. This one is a friends that needed help.

[srad750]

good, glad I could help!