DEAD DP301.10 "full erase"

[jlee337]

I did a full erase (flash 1 & 2) and now my receiver wont power up!
I opened jkeys and backed up my box keys and I tried to do a ecm fix using flash edit.
the problem is when i tried to re-program the receiver with the fixed flashes, my receiver doesnt power up anymore....
what can I do to save it?

[loserbaby]

resurrection method, you'll need wall 2.0, jkeys and some time... write first 60000 to flash 2 and reciever should respond to power, once pwr'd up and jkeys likes it then do full erase and re-write of each flash, any error writing will usually mean you didn't fully erase. try three times to erase( works for me) post back....

[jlee337]

Thanks
I will try it!!
where can I get the dp301 resurrection guide?
I tried looking in the files section but couldnt find it?

[BirdieMod]

I pinned it, Gunther did it and it's in the vid mod, ressurection thread here.
You may need to use jkeys in slow mode, It can take 6 hours but can be done, Let it finish.

The bootstap is deleted and lsi control over the tsop is lost, Be patient and if you get in let it flash...

[jlee337]

THANKS
I will post my results later!!

[skinerd]

Thanks
I will try it!!
where can I get the dp301 resurrection guide?
I tried looking in the files section but couldnt find it?


Echostar files section, about #252 or so on the list.

[BirdieMod]

http://www.dssftp.com/forum/upload/showthread.php?t=19555