No Signal on Known Good connection

[lord_galathon]

I have a 3100 that was working until Friday night. I now get the Signal Acquisition message and it swaps through all the transceivers randomly but I never get a signal. The signal meter is also at 0%, I've tried a hard boot and a check switch on it. The LBN is good because I'm currently running another 3100 on it without a problem.

I was using Atmega. The IRD is subbed though and I tried it with the regular CAM but it's still a No Go.

WTF?

[md2020]

You need to pull the power
wait a few minutes
plug in
- put in card (subbed)
relingk sat or wait it will relink
pull card
put pinb changed card\
wait.....
wait.........
you might have to recheck the switch
yeah its a bitch

[lord_galathon]

Ok, I'll try that this evening. It's been disco since last night so...

PS. What do you mean by pinb changed card? Is there a new Atmega mod with a pinb relation to it? Thanks.

[JShin]

That happened to me before, I kept losing the signal so I ran a switch check, tried unplugging it for a few minutes, nothing worked. I finally reprogrammed my card and it worked so try that.

[lord_galathon]

That happened to me before, I kept losing the signal so I ran a switch check, tried unplugging it for a few minutes, nothing worked. I finally reprogrammed my card and it worked so try that.


Yeah, me too but the thing is, I've tried it with my subbed untampered card. It's almost as if the cable is not connected but it is and it's tested good with signal on another 3100. I'm stumped.

[shaundeyton]

same problem here, If i find a solition ill post it, ive unplagged it for 2 days, reflashed it, and reprogrammed atmega no luck. yet another reciver works 100%, go figure