Erased without saving

[OneHwyMan]

All is not lost.
Find a program called" Flashedit "and find a tsop file with the proper config. Start flash edit prog,open tsop .bin file
then put your ird# and boxkeys in the proper place and save the file. Use jkeys to write it back on and "voila"back in buisiness




OHM:D

[OneHwyMan]

To get your boxkeys use your jeepers jfg file. It all should be there.

OHM

[OneHwyMan]

Ok Goth
What you want to do is make sure your jtag is hooked correctly
ird must be pluged in
detect
anything? if yes boxkeys etc , good news,skip next step
drop down "unknown" select your ird model
Still nothing?Bad news
that model and config hard to find,but I'm looking for you.

need to know exactly what jkeys tells you to diagn you problem
might be just a bad connection


OHM

Does it power up at all???

[OneHwyMan]

Flas edit is a neat little program where you load a tsop flash into it and you can edit the numbers right there.No looking or guessing.

When you put the numbers in ,save that new file so you can use it with jkeys later to put into your ird .
That is it,very simple


Give it a shot
OHM:)

flas edit is in download section under the ecostar files category