bd3 login failed

[ral]

I have a rom 10 at a21, when i try to read or write, i always get bd3 login failed, ive tried every unlocking program out with no luck, can someone offer any suggestions???

[spanky macdouga]

try romopper2.

[smokeyman]

if you by chance were programming this card yourself you could most likely use rom studio to repair it, using the St byte from C0A0,and the Bc byte at C0A1 from the patch or image you were applying at the time

if you dont, you could get lucky buy using the brute force method under commands to obtain the numbers needed to run the backdoor write functions in romstudio


if you get those 1 or 2 bytes, i would think as long as you have the St byte(C0A0) then 00 would work for Bc

then buy opening a good rom10 image (which needs a .bin extention for rom studio)
you could then click on backdoor, enter the 2 bytes in there boxes, then using the write D000-DFFF pull down and select titanium loggin, to perform the repair

Hope this helps you out

[senator]

I actually wish I understood that..lol

[smokeyman]

all i can say that i have fixed at least a halfdozen cams using romstudio

[ralcas]

I'v had rom studio for awhile never had any use for it but its a good program if you know how to use it

[ral]

ive tried rom studio but the brute force method does not give me st or bc values, it always gives me errors reading, ive tried all unlocing progs with no luck

[smokeyman]

ive tried rom studio but the brute force method does not give me st or bc values, it always gives me errors reading, ive tried all unlocing progs with no luck

so you must have no idea on the history of cam, to obtian that St byte

guess there are appox 240 possible combinations eg0 - 99 then a1-a9, or1a-9a, then b-f

last proggy my buddy and i were screwing with was a21 and its C0A0 byte was 44 but that a long shot

anyways good luck