try to convert 301-010 dish to bev

[caminodelsol]

hi all
please need help from all

i have 301-010 dish with p226 update ,i erase SA3 on flash1 put it on bev stream for 2-3 hour no luck dont know why ?
### erase full on flash1 put on bev stream same amount of time no luck.
when i have p225 version i have no problem with convert from dish to bev.
any help please.

thanks

[JT]

A few days ago I changed a 301 into a 3100 by just erasing SA3 on tsop1 and restreaming. It took about 20 min. to update to Bev. It was P226, and now is E469. Without knowing your exact procedure I can't say what's going wrong, but the conversion should work.

[caminodelsol]

hi
i did this b4 with no problem with p225 update version.

right now i have p226 firmware version on my ird.
i did it same like your ird got ECM locationID 0000001.
connect jtag,run jkey after see boxkey click on flash programming
and go erase SA3 dn flash1 and restream with bev
i think i dont missed anything.

thank you very much











A few days ago I changed a 301 into a 3100 by just erasing SA3 on tsop1 and restreaming. It took about 20 min. to update to Bev. It was P226, and now is E469. Without knowing your exact procedure I can't say what's going wrong, but the conversion should work.

[JT]

Sometimes it helps to slip a card in upside down to trip the card slot detector. It's not that hard to do and it sounds like your going about it the right way. Since you say your at P226, I am assuming you can get fully functional with that firmware. I've never switched Bev/Charlie with a receiver at location ID 0000001, but I can't feature that making any difference. Are you certain your hitting 91 degrees with your Bev dish? That seems like the most likely issue for now.

[caminodelsol]

hi
i have 1 ird 3700 with bev ready and watching bev tv everyday ,and 1 301-010 ird with dishnetwork ready.i dont know why i cannot convert dish to bev from 301-010 with p226 update. i will try more until i know why.
thank you very much.



Sometimes it helps to slip a card in upside down to trip the card slot detector. It's not that hard to do and it sounds like your going about it the right way. Since you say your at P226, I am assuming you can get fully functional with that firmware. I've never switched Bev/Charlie with a receiver at location ID 0000001, but I can't feature that making any difference. Are you certain your hitting 91 degrees with your Bev dish? That seems like the most likely issue for now.