fta newbie needs direction

[strongbad]

I have a 30 inch dish,with motor,traxis fta receiver,ku digital ready single lnb,also have a dss dish. Iwant to receive dish and bev satellites what else do i need to purchase and do to accomplish this any help would be appreciated

[xwolfs7]

I have a 30 inch dish,with motor,traxis fta receiver,ku digital ready single lnb,also have a dss dish. Iwant to receive dish and bev satellites what else do i need to purchase and do to accomplish this any help would be appreciated

Hi! if you set your dish right you can get a axle to put both your standard LNB and Ku LNBF on the big dish with this I`ll attach a zip file for picture.then you can use your motorized dish to recieve all your sats on one dish and use your small dss dish for one stationary dish.

then you will need to flash your reciever depends on which model if it is flashable.

good luck...

[strongbad]

not only do I have no sense but I have no patience either i just purchased pansat 2500a does this make my task easier btw thanks for your quick informative response

[xwolfs7]

not only do I have no sense but I have no patience either i just purchased pansat 2500a does this make my task easier btw thanks for your quick informative response


Hi! to flash your pansat you will need a DB9 F/F straight through cable ,
use the X8500_040615_230_api to flash this bin allows you to use blind search.
also find the Al7bar tool uploader and when you flash be sure to flash with
"Flash Rom file mode" if you flash wrong you will have to jtag it .

I posed a readme how to setup pansat 2500a in this section just got to search and put in pansat 2500a you should find the file there.

It should take you about 5 minutes to flash your pansat if you do it right and about 10 minutes for each sat you`re on.

after successfully flashing go to parental control and put in password 1 and 2
password is 0000.

good luck..