keep on "erroring" after each hour

[bigheadshrimp]

hi...I'm using atmega for Bell....don't know why after each hour it will pop up a message saying "there's a serious problem with my receiver and need to contact bell asap".

Also, i cannot watch all the channels, especially the 800's channel and sometimes the 350's.

Anyone get any idea about my problem?

Thankx in advance.

[lp333]

You are being ECM'd by BEV

[bigheadshrimp]

what can i do about that? i have no clue !!!!

can u pls tell me what to do?


thaknz

[DSMdude]

Since I dont recall any current ECMs in the stream, make sure your EMM sigs are up to date in your program.

[balding1]

Having the same problem with BEV and nnw23.
Just changed cam id will see what gives.
No problem what so ever with D!SH and nnw23

[JShin]

Bell will ECM you if you have a blacklisted cam ID, change it and you should be good to go.

[bigheadshrimp]

here's a stupid question...but i'm new to this so....


how do you change ur cam id? i mean...change it to what?

[Nightmarcher]

use scammer

[kissmedave]

I don't know bell but dishnet you need a good blocker.

[jetscott]

same problem here. error 153 every hour. pull card, put it back in and back to normal.

[bigheadshrimp]

when i install the new program nnw23_s2_rev383_tier....it would pop up the message saying that i currently don't have the authorization to view that channel....

is there another problem with BEV?

[jetscott]

same problem here. changed my cam id and took care of it. used scammer2 to create new one.