Small and Big Dish - Setups/Questions??

[tomok]

Re your BUD, you will not get 91 unless you add/change the ku lnb.
91 is the same frequency as 110,119, etc. You can buy a new scalar ring if you have a Corotor II, which has a dbs lnb cut into the ring. This now gives you a C band and 2 ku band feeds. You can then point your BUD to any sat and receive a signal. Of course you have to run another cable for the new LNB.

[tomok]

Sorry for confusion. BUD="Big Ugly Dish"
You can buy the Replacement CorotorII scalar ring for about $50 and it includes the LNBF. The typical dss lnbf will not fit on the Corotor feedhorn as it is circular polarity as opposed to linear for the standard. The dss lnbf also includes its own feedhorn thus the lnbF designation(low noise block feed)
You only have to make sure you use the correct frequency when setting up the 2500a. Standard is 10750 vs 11250? for dss. Check for sure the actual #.
If you have a DISeqc switch you can set up to see all 3 bands from your BUD
If you PM me I will tell you to buy the scalar ring and lnbf