Need help on restoring tsop for 301 010

[yong]

some how my tsop got corrupted and I tried to restore it following the guides from
"Resurrection 301-3100". but after I erased flash 2 and write the first 60000 length, instead of goes on then off, the light keep blinking. it's not behaves as described. if I keep going and erase flash 1, program flash 1 then do the same with flash 2, the light goes on then off, never come back again. jkey reads it correctly after programming but the ird has no video output.
I used both wall and jkey to program it and both write and read successfully, but still the ird not behave the way it should be.
Any suggestion??
Thanks

[terry96]

did you try creating a virgin eeprom after rewriting the tsop?

[yong]

I don't know how to. Could you help?
Thanks.

[terry96]

Use flashedit and load in your software to it. Click open and once your software is loaded then click on tab "save as" then choose virgin image.

Don,t forget to save it to some where its easy to find.

[skinerd]

I don't know how to. Could you help?
Thanks.


Read the Flasshedit help..........

Use Wall and BE SURE the 60000 bytes you write is from the correct flash file, it's easy to get them confused.

[yong]

Do you mean that I use flash edit to make a new tsop then write this new image back to the ird? or flash edit will write the file to the ird. flashedit created two new images for me.

[terry96]

You use flash edit to create the virgin eeprom the write it to your reciever.
When creating this v eeprom enter the build conf. in caps. Use the buil conf on the sticker you will see on the mother board of your reciever.

Flash edit is also used to edit tsops that you may get from a tsop bank so you can match it to your reciever.(ie. box key or ird #)There are other things this is just an example.

[yong]

so do I rewrite the new created eeprom to the reciever before restore the two tsop images by using wall?