dmi2000
07-17-2003, 04:03 PM
Hi people!
I want to share my experience with 0xFFFFFFFF code. I got jtag board from unwink and assembled myself. Plugged in and heare it is, 0xFFFFFFFF = There is a short somewhere. Spend 4 hours on forums looking for solution, check wiring and soldering - nothing. Last idea check Parallel port (25 pins cable) connection wires pin by pin, IN and OUT; gas what? It was no signal on pin 13; signal exists on pin 12 instead. Open connectors on both sides resold wire from pin 12 to 13; assemble connectors and every thigh start working. Try this out.
Rgds
I want to share my experience with 0xFFFFFFFF code. I got jtag board from unwink and assembled myself. Plugged in and heare it is, 0xFFFFFFFF = There is a short somewhere. Spend 4 hours on forums looking for solution, check wiring and soldering - nothing. Last idea check Parallel port (25 pins cable) connection wires pin by pin, IN and OUT; gas what? It was no signal on pin 13; signal exists on pin 12 instead. Open connectors on both sides resold wire from pin 12 to 13; assemble connectors and every thigh start working. Try this out.
Rgds