moving to dish

[tyson1]

Hi All


Just moved my bev dish over to dish i reset my sa on the 2700 and the put the reciver in the stream now the green light flashes 1 and right after flashes 3 times is this ok or did i do somthing wrong

bev 2700 rec with atmeg card

thanks

[BirdieMod]

It should restream in about 5 minutes if all is going well.

[tyson1]

it has been about 40 min since i did it should i try to rest it again

[BirdieMod]

Might be a tsop build not in the dish stream. Dish no longer supports 2700, But updates them to 2800 firmware. Might take a peek in the tsop bank area here and dl a tsop bin to reflash it to. Make sure to save the 2700 image if you want to go back later/

[tyson1]

Thanks birdie

could not find 119 foud 110 but when i got the screen it was all garbage brought my rec back to bev i will read some more and try again later

tyson

[BirdieMod]

Garbage is good, Use flashedit to create a virgin eeprom image and write that to the ird. Then dump sector SA5 and let it restream on dish.