Locals on EMU

[Decal guy]

What controls the locals in these EMU programs. Is it the INI file or the bins? How does one enable the local feed in your area.

[BiggerBear]

Yvous it's the INI file(find your locals and remove " ; " in front of them)
Cemu it's the dish.bin(you have to make a .ne3 file and patch it to the bin)
Chinaman it's the BEV381.bin

[Decal guy]

Tell me how to get it going with the bin in Chinaman

[ber2z]

hi, try changing the last two bits in the blackout string in the ini file to your area. and also try modifying the bin with nagegit and rtm. let me know how you make out

[BiggerBear]

FOR BOTH CHINAMAN DISHNET & BEV THE BIN GETS NAMED BEV381.bin ---
Once you make the .ne3 file just use NagraEdit to patch to the bin.

I Use MiniRTMV2.5
Open MiniRTMV2.5
You need the latest tier list - in the same folder as MiniRTMV2.5
Choose Provider and Rom Type
Select the channels you want(make sure you select the Top AT60,AT180 & AT120)
Notice The Tiers Counter
Click - Add PPV
Click - Create Random(a bunch of times)
Under Decimal - Change the Lowest PPV ID and the Highest PPV ID
Click - Use This(bottom of screen)
Click - Create NE3 Patch
Name and Save someplace recognizable

How To Find PPV Hi’s and Low’s
Tune to a PPV channel with your receiver
On the remote hit the INFO button(not SYS INFO)
Each PPV has a 5 digit code number in prentices(55744)
Copy them and notice the Highest and Lowest.
You then round down the Lowest - If it’s 55744 round down to 55700
To get the Highest add 18000 to the Lowest ----55700 + 18000 = 73700
Some Say The Spread Should Be Less Than 2000, But I Have Been
Using A Spread Of 18000 And Have Been For A long Time.(It’s Up To You)

I USE NAGRAEDIT 4.1 TO PATCH TO THE BIN ---
1) Have the dish383.bin located so you can open it with NagraEdit.
2) Open NagraEdit - Click file - Open Card Image
3) Open dish383.bin - A window comes up -Card Image Type(Leave At Default)
4) Click OK
5) File Opened : dish383.bin
6) Click Tools - Open Card(remove the checkmark in front of Clean Code Space)
7) Click OK -card image cleaned successfully
8) Click Patch - Open Patch, locate your .ne3 file and Open
9) Test Patch - Bottom of screen you should see no errors detected
10) Run Patch - Patch applied with 0 errors
11) Click File - Save Card Image(name & save)
12) That Is You dish383.bin - You need to rename it by removing the .bn3
13) To rename it just right click the file and remove the .bn3(dish383.bin is what you should see until you finish)click on an open area of the page and the file name should be dish383. The .bin is hidden.
This Bin can be used it Cemu or Yvous if the INI file is directed to it.

[Decal guy]

Where can I get a copy of MiniRTM v?

[BiggerBear]

Get MiniRTM2.5 from maestra in the Misc Files, Software & Utilities section Page2.
Also get the new Tier List 8/3/04 by Racer88 in the same section, but on Page1