is my dp310-010 toast

[rookie50]

dp301-010 lock installed oddcircuits AR105
Jkeys returns correct box info, ird# and box keys garbage
Can't get into flah mode (no LSI control)

Wall lets me erase flash but returns flash failed when i attempt to reflash tsop
have reflashed this unit previously after lock was installed but no go now.

am using a good buffered jtag works fine on other units. have top side haeder soldered to board so connections are good. any ideas

[loserbaby]

Remove the lock and ensure all traces are restored, trust me, the Days that you could burn try ing to resurect greatly overcomes the 20-30mins to remove the lock, then if your device isn't recognized "solid" look into a second ground from your jtag to somewhere else on the box... i don't know why, but it often is necesary. Then look up the resurection guide and follow it closely. Bottom line, if you have even remotely messed with the #2 flash and powered down you will need to resurect. If only the first flash, try to restream abd start over reading with the lock gone and an extra ground if necesary....You'll get it.

[the3.9]

and try useing wall