Post Working POT Settings Here for T-911

[Loopey1]

OK folks here is what I was thinking A LOT of people have tried this MOD a few HAVE it working """""ME 4 1""".
So I thought this Post MY Pot settings to get it started Hoping that others will follow Suit. Remeber when reading remove the wires from it first.

MY POT Setting is at 1.823k
And it has worked on all 3 of my Rom 3 cards.

Might be a sticky????

[dell1234]

Sorry for being alittle off subject, but does the red led have to remain on after initial glitch in order to unlock the card. I am getting 6Fo6Fo6Fo.........and if i adjust trmmer i get some other things also, but the led never stays lit up. When i take it down on the omhs until it just times out back it up and it does show an ATR, but the led still goes out once it starts glitching. Any answers or suggestions?

[JT]

OK folks here is what I was thinking A LOT of people have tried this MOD a few HAVE it working """""ME 4 1""".
So I thought this Post MY Pot settings to get it started Hoping that others will follow Suit. Remeber when reading remove the wires from it first.

MY POT Setting is at 1.823k
And it has worked on all 3 of my Rom 3 cards.

Might be a sticky????

I'm just about ready to start this project. Which pot did you use? 5k? I only have 2.2k and 10k in my parts box. I'm thinking I can get away with a 10k but it will be harder to adjust as accurately. Supposedly we can get away with just a 2.2k resistor, but it seems like the right way to do it is to use the .bins provided by Penga to get things calibrated just right before you start doing official unlocking, and you'll need a pot trimmer to do that. Anyone use these mods for unlooping?

[Loopey1]

Sorry for being alittle off subject, but does the red led have to remain on after initial glitch in order to unlock the card. I am getting 6Fo6Fo6Fo.........and if i adjust trmmer i get some other things also, but the led never stays lit up. When i take it down on the omhs until it just times out back it up and it does show an ATR, but the led still goes out once it starts glitching. Any answers or suggestions?
Ya know... I really never looked at my led to see what it was doing.

When I was unlocking the cards I got 6o6o6o6o6o6o6o6o6o6o6o trying to hit bug at whatever it was so I just let it run for a while and when I came back it had popped. I do know this the 6Fo thing ain't quite right. should be just 6o6o6o6o6o
ect...
try and get it to show just 6o6o6o6o and let it run a while see what happens.

[Quincy]

i am getting 6Fo6Fo how do i get it to go 6o6o6o i am using a nexus moded t911