help flashing Mik III with Win98SE

[littlelarryjr]

I cant use the XPflash, how can I flash my MikIII so I can start testing my mod? I am going to crap shack in a couple of hours for a trimmer and a on/off switch. All my soildering is done. YAAAA!

[JCK7]

TRY this link kkk 5.1 did remove jumper. JCK7



http://www.dssftp.com/forum/upload/showthread.php?t=31662&highlight=JCK7

[littlelarryjr]

I have KK, but I want to flash my newly build A23 popper LOL with the NEWD hex's. Do you understand what I mean? I want to make sure I am wording it properly. I moded my Mikobu 3 and now I need to flash it, but I am running 98 so I cant use xpflasher like everyone else. I need to flash the chipin the loader with the newd.hex files, but I dont know how?

[littlelarryjr]

thanks but no, I already have them,

I cant run xpatmel.exe because I am running win98. Am I correct that there is no way to flash this thing unless I am running winXP?

I am sure I am not the only guy not running WinXP?

I have Flash.hex and eeprom.hex, but no way to get it onto the loader I moded.



People Dig Deep! I am not looking for a hand out, just a hand up.

Thanks again for all reply's.

[indal_98]

thanks but no, I already have them,

I cant run xpatmel.exe because I am running win98. Am I correct that there is no way to flash this thing unless I am running winXP?

I am sure I am not the only guy not running WinXP?

I have Flash.hex and eeprom.hex, but no way to get it onto the loader I moded.



People Dig Deep! I am not looking for a hand out, just a hand up.

Thanks again for all reply's.

1) fpr16 for flash.

2)Jump 232 pin 10 to AT90S2313 pin 18 to flash.

Dig ?

[Gillis65]

When using fpr16 for flashing let's say the newd6.exe.eeprom.hex and Newd6.exe.program.hex onto the MikIII for rom3 opening, do you need to flash both or 1? Or is it even possible to flash both? Thanks

[Eldune]

littlelarry, Here ya go!

[Eldune]

When using fpr16 for flashing let's say the newd6.exe.eeprom.hex and Newd6.exe.program.hex onto the MikIII for rom3 opening, do you need to flash both or 1? Or is it even possible to flash both? Thanks

You only can use one at a time. Use the one I posted much easier.

[Gillis65]

Thanks, I'll give it a try. Is there a test program for open rom 10's, i only see one for Rom 3?

[littlelarryjr]

I as well am looking for the Rom 10,

[Gillis65]

Finally some progress, got 1 rom 10 to pop with the newd8 flash. Settings 52,50 no pot just 2.2k resistor. LittleLarryJr-open the rom10a23 file you can switch to test mode (1) MiKIII mod working finally. Thanks for the flash Eldune.