Absolute 1 mods

[Chicodog#1]

Do any body know or have the diagram on how to mods absolute 1?.

[harrybuckman]

I want to see this too. I hope we get a schematic.

[nebur]

absolute 1 mod

[Chicodog#1]

Thanks. That was fast. I going to try it and I let you know. :repuke: :repuke:

[Chicodog#1]

absolute 1 mod
Thanks. for the diagram. The only things that are a little fuse is the lines to cut. on U1. I cut line of leg10, on U2 line of leg 18, U5 line of legs 1 and 2. Please tell me if I'm wrong. I have a magnifier glass but still can't make the lines to cut. Any help will be appreciated. Thanks. :)

[Rax]

Note: Absolute 1 you have to remove the card slot to cut some of the traces
From what I understand the Absolute 1 Premere is much easier :rolleyes: Same as the t911 other than the jumper settings

[JCK7]

Rax Do have mod pic Absolute 1 Premere and do take card slot off . I have ALPHA 1 also . which best easy do mod on ,. thanks JCK7

[Rax]

Rax Do have mod pic Absolute 1 Premere and do take card slot off . I have ALPHA 1 also . which best easy do mod on ,. thanks JCK7
The absolute 1 premere there is no need to remove the card slot (as per the site below) only the absolute 1 needs the extra work...
I read this at cardcoders.org they seem to have all the mods for loaders.

Hope this helps out

[farmboy491]

I mod'd an AB1 premier, but to access the 74hc4053 to tie in the pot, the card slot needs to be removed. I opted for the pocket knife method and just cut the center brace off the top of the card slot to gain access. Just scored along the side untill it cut through. Now can run without it, or simply glue it back.

Anyway, got an AB1 premier up and pooped my only rom10 A23. Had to use Anarky's unlocker program though, could never get the winx scripts to work.

[Rax]

Hey farmboy could you post some picts? I think every one w/ an absolute1 would appreciate it

[farmboy491]

I can post pics, but my mods are basically the same as the ones posted, I mod'd my way, but acheived exactly the same results. I cut traces in dif. places and wired in at dif places, but all are the same mods as those posted. I will try to remember to take some pics tonight and post tomorrow.

[JT]

I managed to get my absolute1 Alpha glitch series unlooper successfully modded last night. Here is the pic I used from Bushwackers. It's the same pic as above but in much higher definition. Thanks to Bushwackers for his help and pics. I didn't do my mod exactly like he has it pictured. For instance, instead of trying to cut the two traces between pins 1&2 and 2&3 on the 74hc00 chip I just lifted pins one and two. For the flash enable/disable switch I just lifted pin10 of the sipex chip and put one lead to the switch off the lifted pin and the other lead to the pad I lifted the pin off of. There are a bunch of different versions of the absolute1, but this how to should work for all of them that I've seen. Dipswitch 1 on for flashing and dips 1&5 on for programming.

[Rax]

Thanks JT :)