black screen with yvous

[timinator]

i had been testing yvous . then i got a atmega card . so i took yvous out of the streem for a couple of days but left the program running so i could test the atmega.
in a different rec. when i hooked yvous back up all i get is a blank screen . the program shows that its running . i pulled the board and reinserted it it goes through with powering off the rec. thenaquires sat sig. then black screen . i have chan menu
any ideas? thanks

[chupame69]

Yvous 1.3d beta is running fine here for me on two 301 IRD's.

[rving]

Got this off another sight and pasted it here:

This has now been confirmed as correct. I took it to the "top" level in this hobby and it is confirmed.

blue caddy ----- of course you are still up. You may not understand why so here goes. An emulator has no blocker on the eeprom like a card being tested. When the stream sends parity modifications the eeprom running in "computer memory" is updated just like a sub card would be. As long as your emuter continues to run, the bin file is OK because the parity has been updated. However; when you shut down Yvous and restart it (say for a PPV string update) the ORIGINAL Dish383.bin file will be launched by the ini file.----- that bin file does NOT have the current parity keys and therefore your emu will not run. TODAY -- any freshly launched Yvous system will run because the stream is still updating parity. As soon as the update leaves the stream any ORIGINAL Yvous bin files will be DOA as the emu system is started !!

Change it now, it takes mere seconds.

How to change the key:

1.Opened the dish383.bin using nagraedit
2. Hit the patch tab
3. copied and pasted !Modify 07 02 04 0F B487666D05EAD1ED74E55BD6252038 in the patch editor
4. test patch.
5. run patch
6.save file as dish383.bin (make sure its named correctly after the save)
& thank the dish gods and watch tv

[timinator]

thanks for the help. all is well with one but the other one goes for a while then goes black then comes back on again . both are 2700's with yvous

[felix the cat]

Been runing Yvouse 3.1d with dish381.bin (that came with prog.) for dishnetwork.
for about 3 months now.
Above post says patch new parity keys to dish383.bin.
I patched the new keys to my dish381.bin, and still have to wait for the keys to roll everytime i need to reboot . is that normal ,or would it be better to patch to dish383.bin, and where would i get it ?
Thanks in advance.

[rving]

I use Yvouse 3.0, not beta, came with dish383.bin only.