Can this unlooper be MODded to open Rom3

[balaban32]

Hi,

I need some of you more technical guys to help me with this. Pictures of my unlooper are attached below. I beleive it is a Tuker schematic, but I am not sure. Can it be Modded to open Rom3 and how. I have read in other threads the post by no1b4me which says that any Tuker type can be modded but mine does not match exactly to his part descriptions, scecifically I don't have a LM358. I have done about as much as my knowledge allows, now I need someone wiser. Please help.

[balaban32]

0 replies so far. Any susggestions guys? Does anybody know another good forum where I might be able to get help? thx.

[LuckLarry]

I would think it could. Try the forums at cardcoders. There seems to be a great deal more conversation on obscure loader mods.

[Caesar_Mikey]

I dont see why not just look up the mikbou 3 mods

[LuckLarry]

I think its closer to the original "Tucker" design. That circuit topology was typical of most early unloopers.

[balaban32]

Thanks LuckLarry. I think this is closer ot the Tucker design as well, I looked at the Mikobu mods, but they look different. I will try cardcoders. This is a WhiteViper unlooper, I thought they were more popular than this, but it does not appear to be the case.