2800 dish to bev no go

[gatortate]

2800 would not power up when converted to bev so i erase whole flash and put the old bin back on and then it power up,so i erase sa5 3 times again and try to convert back to bev still would not power up any ideals.

[JShin]

A 2800 should update to a Bell 2700C but if that process isn't working for you just down load a Bell 2700 Flash from the TSOP bank edit the boxkeys and write it to your TSOP.

[gatortate]

thanks jshin i will try that not sure how to edit the box keys will the new bell flash have the boxkeys?i did restore the old one and ierase sa5 again but that did not work for me,power light did not come on.

[LuckLarry]

thanks jshin i will try that not sure how to edit the box keys will the new bell flash have the boxkeys?i did restore the old one and ierase sa5 again but that did not work for me,power light did not come on.



If your led doesn't light, there's a good chance you're eeprom is corrupt. Download a full bin for your build, as close to the newest firmware possible. Load it and you should be good to go.

[Chapster99]

thanks jshin i will try that not sure how to edit the box keys will the new bell flash have the boxkeys?

No. You will need to download Flashedit2.0.1a. Use that proggy to edit/enter your IRD #'s as well as boxkeys. Then 'Save As Personnal Dump'. Then hit the Save Virgin EEprom. Then go back to Jkeys and reflash your IRD with the newly created TSOP.

[0zone]

Read the guide in my sign named "GUIDE Jkeys/flashedit crash course."
It will guide you step by step 0zone

[squid]

do you have a bin for a 2800 with a build conf." cana for bev" .The one that I downloaded form dssftp is corrupt. My receive does not seem to be able to download new firmware.