modded mik3

[robo]

any ideas Data : A0
TX Data : A1
TX Data : 07 0E 03 10 01 03 9A 00
RX Data : 06 00
TX Data : 12 15 AB 21 00 08 A0 CA 00 00 02 12 00 06 55 0E
03 85 00
RX Data : 03 00

Now we will try 123E delay
RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET RESET

[littlelarryjr]

Try taking out the 2.2k resistor and using a POT switch instead. Thats what did the trick for me.

[robo]

i have a pot switch in it

[littlelarryjr]

as you rotate the switch slowly it stays on Reset? If this is the case, check to make sure the leg is totaly seperated from the board where you attached the pot switch.

[robo]

so rotate it slowly while the script is running????