Streamming Problem

[gwabitz]

Here is my problem

I have a DP301-013 single TSOP
I did the vid mod, changed 7FFFFFAC to 0000
Erased SA49 four times w/R79 grounded
Ungrounded R79
Hooked up sat feed, plugged IRD in to stream
IRD streams but never gets to the end point where you get the message "insert your access card"
It just shuts off
If I insert my atmega card I get ppv channel,others are black and if I press channel 120 I'll get 121, 184 I get 185 etc..
I know my code is good,IRD # etc.
Any other IRD I've streamed always showed the insert card message
I've done this over and over with the same result
Any thoughts?????

[littlelarryjr]

Sounds like the mod is not correct. I would double and triple check all the conections, go have a smoke and check them again

[gwabitz]

I double checked my connections for vid mod and everything looks OK
I'm using the mod from Gunther's guide

[BirdieMod]

Hit "Sys info" your remote, Did it update yet to P204? 301-013's starting at about R00-56xx.xxxx will play with you a little at first after the vid mod.

[gwabitz]

It does show P204 and my IRD starts with R00 56XX-XXXX
Would a bad CAM ID cause problems? Because when I insert my atmega card after a while I will get the message "smart card inserted wrong"
I'm using a CamID that was with the program and not a generated one from a cam generator
Also after the card has been in the IRD the P204 will then read X204 in the info screen
If I run Jkeys and restream it will show P204 again, but still won't finish restreaming with "insert valid access card"
If it is a bad camID where can I find a link to a cam generator?
Thanks in advance!

[gwabitz]

Well I figured out the problem.
It looks like it was the code.I went to the file download section got a new code w/camid put it on the atmega and now everything seems to be working fine.
Figure that one out! How can the code work for my other IRD and not this one?
And I never did get the insert access card message after streaming.
These DP301-013's sure can be pain in the ass!