Qcemu

[Double Duce]

Can anyone tell me if the QCEMU software is installed on the emu computer or is it placed on another computer? Not sure what to do.

Thanx
DD

[bOZZ]

install QCemu on a Windows based computer (Win98/98se/ME/XP) .. run it from the icon on your desktop ... it will create the DOS based bootable floppy for Cemu emulation on Bev .. ( it's just a gui editor etc.)

[Double Duce]

What software do put on my emulation computer that will be hooked up to my receiver?

DD

[bOZZ]

QCemu creates a bootable floppy ... no other software is needed ... boot the computer from the floppy and it will load the o/s (DOS) and the Cemu emulation program (in a RAM drive) ...

make sure your AVR/max-mell board is programed right ... double check your emulation cable ... and if your com port is working ... you should be good to go ...

[cancom]

What software do put on my emulation computer that will be hooked up to my receiver?

DD


If you are still having trouble, PM me and I'll send you a bootable disk build program that will only require you to change the boxkeys and IRD# to get going.

cancom

[Double Duce]

By the way guys I'm using a bell 3100. The program QCEMU is the program I'm using to make a boot disk. There is just one thing how do I know which rom card do I have. After creating my boot disk when I click on the save button a message comes up that say $ is not an interager what does this mean? The instruction say the box key is in the hex file so do I leave the box empty when creating the boot disk.

DD