rom2 hepl

[hazel]

Iam new to a rom 2 but I have done rom3 and 10 but i was wondering if there is a good walk through to help me along

[pyle]

Iam new to a rom 2 but I have done rom3 and 10 but i was wondering if there is a good walk through to help me along

make an ne2 patch in tiergen. check the blackout string and make a wide open ppv string
read the card in nagra and save the image
remove the card from the programmer
open the image in xcel 3.6
under eeprom utilities run clean and refresh to rev052
under tools click patch eeprom
in the box that popped up browse for the ne2 patch you created with tiergen than hit apply changes to open eeprom
save the image
open nagra3 or 4.1,read card,apply card image(the image you just saved from xcel)
write to card.
you may need to run it on ch 101 for 15 minutes depending how long the card has been out of the stream. eventually you will have to take the wide open ppv off so use the image you just wrote to the card with and poke around with and see if you can figure out how to remove and add tiers to it.

[hazel]

thanks for the reply i well give it a try