Green light 301-013

[mikebike]

Hello
After the last ECM 10/27/04 my IRD 301-013 have a problem, when I plug it to AC the green light pwer on for 3 seconds and turn off immediately and nver goes on again, somebody tell me about to erase the SA49 but I am not sure to do that because this is not the typical problem to perform this procedure.
I am a newbie in test some body help me, Thanks Mike

[brad22773]

Attach a second ground wire to your alligator clip of the JTAG and solder the second wire to PAD #1 and connect your JTAG and plug in the IRD to power source open JKEYS 301.013c and click on flash programming click OK on the pop-up window, the next window click the pull down menu at top right of the screen and choose SA49 in pull down menu and click erase about five times. Then click the program button and it will ask you if you want to program that address click YES and see if the browse window opens to search for the file you want to write. If it does then you have successfully erased SA49. Unplug power unhook JTAG and ground wire and place IRD in stream and wait for it to come on.

[Crazy1_79]

it seems you have to restream it with a virgin yellow card after the last ecm, at least that was the case for some people.

[rafter94]

it seems you have to restream it with a virgin yellow card after the last ecm, at least that was the case for some people.

With the lock open!