301-10 flash not erasing in WALL

[corrosive_acid]

I have a 301-10 with an oddcircuits lock installed.. teh flash got completely corrupted so i'm trying to resurrect it usign flash however wall doesnt seem to be erasing it properly, the times it does erase and i program u23 at 60000 the power light never lights up :( .... does anyone know how i could fix this problem?

[FooloishMagoo]

same here I have trying to use wall it says that it erased but nothing happends I cant reporgram even though it said that it did

[corrosive_acid]

so.... is it toast?

[skinerd]

Sometimes a blank or corrupt -010 can be a bit finicky, Wall will work sometimes, and jkeys will work sometimes, just have to keep trying until you find what works. Jkeys and Wall don't agree with the numbering of the flashes and it's easy to get confused.

[corrosive_acid]

is there a way to ressurect with jkeys and not wall?
the only thing with wall is that it will atleast program the flash? but i dont know why the green light doesnt come on/off.
i'm using weights on top of the jtag so i know that it doesnt move... i'm thinking of soldering over some of the jtag contacts cuz they seem to be getting weaker but i'm not sure that wil make much of a difference.

[skinerd]

Sometimes jkeys will, or can be made to, resurrect a 301-010, I need the specific error you get when trying to advise how to continue.
It should detect the device, no matter what, but getting into a blank or corrupted flash may require modification to the jkeys def file. I have resurrected every -010 sent to me that was not physically damaged, and a few that were.

[corrosive_acid]

wow, well i get that LSI control thing
i'll try it again soon and let you know, cuz i DO remember u posting somethign about moding the def of jkeys in some older posts when i was searching.. i'l check it out and let you knwo