Error DCU Peek

[zebra3]

Hi I have a 301-013 and when I try to read with jkeys a ERROR READING FROM IRD (DCU PEEK) AND NOW MY RECEIVERS LED WONT LIGHT UP ANY COMMENTS

[Rax]

Ground r79

[zebra3]

What do you mean by ground r79

[minotaur]

Connect a wire from resistor R79 on the circuit board to the metal frame of the box to "ground" it...then try re-reading the TSOP with JKEYS...

[zebra3]

let me try

[Rax]

open up your IRD, find r79, solder a pin on r79 and ground to the case

[zebra3]

doing it right now wish me luck

[zebra3]

if am lucky once I read with jkeys sould I proceed erasing SA 15

[zebra3]

i did it i could read it with jkeys now what ? erase sa15 because before all this it was on lc id 0001.

[j0intheparty]

I am getting dq5 errors when tring to erase / write new tsop is this a lock issue?

[dishrag]

Zebra3 I sometimes get the same error with my 2700. All I have to do is push the plug in by hand so it makes better contact. This works everytime when I get that stupid error.