2800 reciever help plzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz

[deusman]

i saved my flash for 2800 , erased teh whole flash an dthen reporgrammed it with the saved flash, also had saved the eeprom , programmed it with flash edit and then put it in my reciever thru jkeys,
now after reprogramming my entrire flash , when i connect teh reciever to the satelite , it gives me teh location id 00000001, n when i put in the card it says " adduiring satelite signal , please wait??
i have erased my flash twice and have reprogrammed it twice as welll, but when i plug it back in the reciever turns on right away , goto the sys info screen and location id 00001 and when insert trhe card, it says aqquiring satelite signal plz wait, any help?

[deusman]

ok i got the location id now , its now 00001111, prolly it was cuz of teh softlock , i was just reading and i found out 2800 doesnt support softlocks , so i took it offf, now when i do teh check switch , it says no switches detected and when i get outa teh system info menu , it is stuck at aqquiring satelite signal please wait , why?????????????

[deusman]

the location id is not 0000001 any more, *** typing error above*****

[321]

Find any other Tsop file with same build configuration and put it in it might help
also check if you have signal.

[JCK7]

the location id is not 0000001 any more, *** typing error above*****


\Use menu see if have sig then do switch check .

if all ok cancel out let search sig you get in 15. 30 min

[RaceFan409]

Did you restream it without the card in the receiver after you got the location id where it wasn't 001? If not, that may be at least part of your problem. If that doesn't fix it, I'd go with what 321 said in his post.