PDA

View Full Version : T911 Nexus - what else to try?


chadjo
11-09-2004, 09:36 PM
I'm having problem with unlocking my rom 10 rev a16 (spoofed to a23 from blocker) using modded t911.

I was playing with vcc, dips, tried resistor and trimpot but all I get are:
all resets, then somehow I managed to get all FFFFF's, and then somehow I managed to get mixtuere of FFF's and 000's . But that's it, ... no lack to unlock it. The card still has bd3 disabled after Oct 27 hit.

Any idea?

Thank you in advance!

cisco356
11-12-2004, 09:09 AM
I can't get a single card to pop. I also got a factory moded Nexus T-911

tattooguy77b
11-12-2004, 02:17 PM
OK guys here is some info on the Nexus T911 moded loader.I have also purchased one from Dishmonkey.I haven't yet popped a card but this is what i get.6F6F6F6F6F6F6F6F6F6.........this is what you should have and then you are close.My friend said that he has seen some pop in minutes and some in hours,here are my setings.

Newd9 Flash
Flashng = Pin 1 up only
Loading = Pin 5 down only

You just have to try playing with your pins,they are not like the usual 1+5,2+5.Let the script run and play with your pins and watch what you get.

Vcc Start = 1A
Vcc Limit = 14
Delay Start = 10A4
Delay End = 12F9

Good Luck

terry96
11-12-2004, 03:18 PM
Hi guy's, Well I got the nexus t911 And had success popping two 10a81's lastnight. first of all newd 9 is gor a23 and newd8 work well on a81.

with my ohm meter I set the trim pot at exactly 2.2 and run loader with switches 2 and 5 on.

Iran vcc analizer 1 then when it was finished, I took those #'s and put them in vcc analizer 2 and then finally putting those #'s in the unlocker script.

Now that I've narrowed the gap I also changed the start delay to 0D00.then ran the script. My first one popped at 0D06 and my second one popped 0E52.

Hope this information can help you guy out


Also most of the time my scripts ran they didn't have a whole lot of 6's in them

FFFFFFFFF6FFFFFFFF6F6FFFFFFFFFFFFFFFFF6FFFFFFFFFFF F6FFFFFFF6F6F

This is how they looked

tattooguy77b
11-12-2004, 07:44 PM
I'm usigng Ufp16 for flashing and there are 2 Newd8 files.
Eeprom.hex
Program.hex
Which one do you use to flash with or do you use both?All iget is

6F6F6F6FFFF6FF6FFFFFFFFFF6FFF6FFFFFF6F6F6F6F6F.

Realbadman
11-24-2004, 05:13 AM
thisis what iam getting