ecm'ed sub receiver's

[nash1]

Hey guys, does anyone know where to send ecm'ed receivers to be fixed,
i just got a jtag and cannot get it to work "device unknown" no tv for 2 weeks
just frustrated.

[musclesz]

where are you located

[JOE SNUFFY]

Check your prefrences. Using Jkeys click on File then Prefrences then choose Ox378 their are 2 other choices if that doesn't work. Also sometimes try no batteries. Also you can try no batteries then put 3 volts positive to the red wire (on jtag that should be the wire all the way to the right when hooked up and the ground pads facing you and the jtag pads away from you) on the jtag and 3 volts ground to the chasis also connect the jtags ground to chasis.

Joe

[livnitup731]

Hey guys, does anyone know where to send ecm'ed receivers to be fixed,
i just got a jtag and cannot get it to work "device unknown" no tv for 2 weeks
just frustrated.

I'll bet you 10 bucks that your jtag isnt connected properly to the ird or the jtag itself needs to be rewired. Check your resistors and make sure they are in the right spots, and check the jtag connections to the lpt connector 5 more times. I bet you'll notice a dumb mistake. Good luck.

[ALAUDY]

I tried for 2 months untill I went to rad shack got some resistors,wire 25 pin con. and made my own soldered the jtag onto pads. worked first time