badger213
11-24-2004, 11:20 PM
This is new one for me and I haven't read anything about it. I just jtagged a 301.10 and everything went smooth. Got box keys,ird#,build ect. Went into flash programing and saved both tsops and eprom. No problem. I then opened flashedit 2 to see if files were saved ok and boooom. I got an error message that said it was not going to allow me to open these files (2) because the checksums are not right! I then hit the advanced tab and up come ird info and its all different then what I jtagged. What gives???
OK, shortly after posting this I did a search using "checksum" and low and behold I'm not the only one having this problem with the 301.010. I tried changing the positions of flash1 and flash 2 in flashedit with the same results. I'm using a bufferred jtag and it mounts under the bottom of ird, makes good contact and I don't have to hold it. Tried several flash saves, erased the old ones, but still getting same error????/
OK, shortly after posting this I did a search using "checksum" and low and behold I'm not the only one having this problem with the 301.010. I tried changing the positions of flash1 and flash 2 in flashedit with the same results. I'm using a bufferred jtag and it mounts under the bottom of ird, makes good contact and I don't have to hold it. Tried several flash saves, erased the old ones, but still getting same error????/