unlocking rom 3 ???

[teknikal]

ok i finally got my loader modded and am trying
to get unlock rom 3 all i am getting is 06f06f over and over
i don't have an open one to run test glitch on
i do have a rom 10 that is open should i use it to get settings
i don't want to mess up my rom10 though
the loader i am using
is a t6 i believe it has 6 blue dip switches
also i was going to reflash using uf16 but keep getting erors
any help on how to use this flah utlity

[Crazy1_79]

if you are getting 6f0 you are on the right track, just let it run. Mine usually takes quite awhile to unlock rom 3's I ususally let it run overnite when I go to bed and when I wake up it is open.

[teknikal]

thanks i will let it run overnight and see what happens

[teknikal]

still just getting 06f i let it run all night

[Cid6.7]

Same here ran all night & untill 4pm the next day still o6F..Dangnabbit

[teknikal]

well i let it run all day and nothing still same 06f
when i adjust vcc nothing happens still the same 06f
i am using a 2.2 resistor no pot
so i don't know what the to do
should i use my rom 10 to get settings or what
i don't want to mess it up though

[teknikal]

i let it run for almost 2 days and nothing but 06f
any ideas

[eeeprom]

i let it run for almost 2 days and nothing but 06f
any ideas
you need pot and adjust the resistance to find good value it DOES work

[chithead]

I had the same problem. this is what i did ...mod mikobu3
set pot to 1.8 ohm (only setting i got testglitch to work with)
VCC: h62
Type: h06
Delay: 10A4
it still took about 3 hr for one but most pop within 30 min's
good luck .... dont give up...

[teknikal]

cool i guess i will replace the risitor with a pot and try that